Economy

JAFX AI Explains Position Sizing, Step by Step

Ask a newer trader how they chose the size of their last trade and the honest answer is often “it felt right”: a round number, or whatever the account would allow. That is the wrong way round. Size should come out of a calculation that starts with how much the trader is prepared to lose if the idea is wrong.

JAFX builds that calculation into JAFX AI, the assistant inside the JAFX Terminal. First, the terms.

Four words worth knowing

Lot. A unit of trade size. On currency pairs one lot is 100,000 units of the first currency, so one lot of EUR/USD is 100,000 euros. Trades can be far smaller: on JAFX the minimum is 0.01 lot.

Pip. The usual unit of price movement on a currency pair: the fourth decimal place on EUR/USD (0.0001). On one lot of EUR/USD a pip is worth 100,000 × 0.0001, or $10. On other markets the value differs; the instrument’s specification in the terminal can show it.

Leverage. The ratio that lets a trader hold a position much larger than the money put up. JAFX offers up to 1:500 on forex and metals and less elsewhere. Its own risk warning is blunt: at 1:500, a 0.2% move against a position wipes out the margin supporting it.

Margin. The collateral set aside to hold a position: its full value divided by the leverage. Margin is not the amount at risk; a position can lose far more than its margin.

Start with the loss, not the lot

The general formula:

position size = amount at risk ÷ (stop distance × value per pip or point)

A worked example, with hypothetical numbers chosen to keep the arithmetic easy:

Balance: $2,000. Risk per trade: 1%, so $20.

Idea: buy EUR/USD at 1.1000, stop loss at 1.0975, which is 25 pips away.

Value per pip: $10 for one lot.

Size = $20 ÷ (25 × $10) = 0.08 lots.

Check it backwards: 0.08 lots move $0.80 per pip, and 25 pips of that is $20. With a 50-pip stop, the same $20 would allow 0.04 lots. The stop goes where the chart says, and the size adjusts to fit.

Now leverage. The position is worth 0.08 × 100,000 × 1.1000, or $8,800. At a hypothetical 1:100 the margin would be $88; at 1:500, $17.60. Either way, the loss at the stop is still about $20. Leverage changes the collateral tied up, not the risk of a trade sized this way, but it makes a far-too-big trade very easy to open.

Costs come on top: JAFX’s commission of $4 per lot, charged once at the open ($0.32 here), and the mark-up in the spread, shown before every order. In a fast market a stop can also fill at a worse price than the level set.

How JAFX AI does the arithmetic

A trader can tell JAFX AI how much to risk, as a percentage of the balance or an amount, along with the idea. JAFX’s own example request is: “short EUR/USD at the nearest resistance, 2R target, risk 1%” (2R meaning a target twice as far away as the stop). JAFX AI drafts the trade with entry, stop and target, and a size worked out by a calculator from the live balance and the chosen risk.

The draft arrives as a card. Its “At risk if stopped” line shows the loss at the stop, in the account’s currency and as a share of the balance, with the risk-to-reward ratio. A draft without a stop carries a warning that the loss isn’t capped. Nothing is sent until the trader presses Confirm, and the card expires after 10 minutes.

The order ticket can do the same by hand, sizing an order by the share of the balance it would lose at the stop, always rounding down. Contract sizes, minimum lots and maximum leverage for every market are on JAFX’s page on JAFX lot sizes and leverage.

What no formula fixes

Sizing from risk limits the damage from any one trade. It does not turn a bad idea into a good one, and it does not make leverage safe: leverage multiplies losses exactly as it multiplies gains. JAFX AI explains and calculates; the decision stays with the trader.

JAFX (PTY) LTD is an authorised Financial Services Provider (FSP No. 52058) regulated by the FSCA. Trading leveraged derivatives carries a high risk of losing money rapidly and is not suitable for everyone.